Thank you for buying our circular knitting machine You will become a friend of EASTINO circular knitting machine, the company's knitting machine will bring you good quality knitted fabrics. In order to give full play to the performance of the machine, prevent the failure that should not occur, and avoid safety accidents, please be sure to read this manual in detail. Note the following points
1.the circular knitting machine adopt three-phase AC power source. Voltage AC3*380V,50/60HZ.
2.the machine additional requirements have compressed air source. The air pressure is 0.5-0.8MPa.
3.The circular knitting machine is supported by foot pads. Before the circular knitting machine runs, be sure to use adjusting screws. The circular knitting machine covers an area of 3.5m*3m, floor bearing capacity ≥5kg/cm², the ground is hard cement ground, roughness is 2mm.
4.The circular knitting machine has a high voltage power supply, and in the work, the machine is rotating. Careless operation may result in electric shock and injury. Minors and personnel unfamiliar with the circular knitting machine should not approach. Operators should be professional training and learning and obtain the corresponding certificate to operate.
5. If anything abnormal is found, please press the "Emergency stop" (red button) quickly. If leakage or electric shock is found, the air switch equipped with the machine will trip in a short time to ensure the safety of the operator and the machine. In this case, it is necessary to find out the cause and to rule out before starting again.
Danger!
1.Power supply must be turned off when wiring is implemented.
2.Absolutely not on the machine to refit.
3.Check whether the machine is properly grounded before starting.
4.This machine is only used to produce knitted fabrics.
Warning!
1.Only qualified professional electrical personnel can install, repair and maintain part of the machine circuit.
2.Only professional personnel can debug, repair and maintain the circular knitting machine.
3.The rated voltage of the power supply system installed on the machine shall not exceed 380V.
4.Each time period, it is necessary to confirm whether the safety equipment works normally.
5.The operator shall not wear loose clothes and long hair.
6.Improper use of circular knitting machine may cause danger to people and equipment.
Product brief introduction
Single side small and medium-sized round weft machine adopts closed four track design, high output, good fabric quality, even if you buy other conversion parts, but also can quickly recover the cost, the overall appearance is exquisite, simple. All adjustment points of the fuselage rely on external force, very convenient operation. Drive system adopts advanced frequency converter control, so that the machine starts
Content
1.Precautions for unloading and installation
2.Precautions before starting the machine
3.Instructions for use of control buttons
4.Maintenance and adjustment of needle accessories
5.Maintenance of motor and circuit system
6.Speed adjustment, recording and input
7.Oil nozzle
8.Safety door protective cover
9.broken needle automatic stop device
10.Yarn storage device
11.Radar dust collector
12.Technical standards of loom
13.double-sided round weft machine knitting mechanism, classification
14.yarn feeding aluminum plate adjustment
Post time: Sep-26-2023